Installing Windows in Your Home

If the windows are broken or cracked then you need to install new windows in your home. Having glass windows installed could prove to be expensive if you hire a local glazier Macleod which is why you might be considering on installing the glass windows on your own.

Windows provide character to a home which is why it is important to have good windows in your home at all times. Follow the below instruction to remove the old window in your home and install a new one.

Step 1: Remove the Window Casing
Firstly, you need to use a prybar to successfully remove the old window from the window casing. You will need to jamb the extension around the old window in order to remove the old window. The casing is just a piece of wood which has been attached to the window jamb to hold it onto the wall.

Step 2: Remove the Old Window
Now, just unscrew the old window from the jamb to remove it. Be careful not to break the glass while removing it. Windows which have multiple window sashes that have moving tracks on their sides are easier to remove.

Step 3: Repair the New Window Opening
Once, you have removed the old window, you can inspect the condition of the window jamb to check if there are any damages to it, if you see a rotten jamb then you will need to remove it with a new one. Do measure the rough opening to ensure that it can accommodate the new window with ease.

Step 4: Replace the Window Stop
The window stop is just a piece of wood which is placed right around the exterior side of the jamb. It helps to prevent the window from sliding out through the opening. Usually, the original stop would be in a good condition; however, if it is not then you will need to get it replaced too.

Step 5: Dry Fit the Window
Now, before you actually apply the silicone to the window stop, you need to dry fit the window to ensure that there are no fitment issues. However, if you do see any fitment issues, then you would need to address them now or else you would need to do it again. When done right, the window will perfectly fit in the opening. Do not continue on with the steps if you find the window has not fitted properly.

Step 6: Install the Window
It is quite simple to install the window. All you have to do is run a bead of silicone onto the inside of the edge of the window stop and then simply slide the window into it. Press cedar shims between the bottom of the window frame and place it a level on top of the window. Now just make sure to place it as needed to allow the window in a sitting level.

Just follow these 6 steps to properly install windows in your home without having to hire anyone, if you do need a professional call Smith Glass.